fly with the wind > Mini SpeedWing 250


fly with the wind
osamu's rc flight

Mini SpeedWing

Mini SpeedWing 250 w. 300DF

PRODUCT:

Mini SpeedWing

MANUFACTURER:

SpeedWing.NET

CONSTRUCTION:

EPP foam wing reinforced by carbon fiber, covered by colored tape, balsa elevon covered by Oracover, Coroplast winglet

FUNCTIONS:

Elevon, Throttle

WING SPAN:

24"

WING AREA:

168 sq. in.

FLYING WEIGHT:

7.7oz (w. TP3S900)

RC GEAR:

Castle Creations Micro Stamp 4L receiver
2 x HiTec HS-55 servo

DRIVE SYSTEM

JustGoFly 300DF BL outrunner motor
GWS 4x4 or APC 4.75x4.75 prop for 3S, APC5x5 prop for 2S Li-Poly pack
Castle Creations Thunderbird 18 ESC
TP3S900 or 2S1320 Li-Poly pack

building:

I built my MSW with some modifications:

1) Motor mount for 300DF made from 1/16" ply is attached to the ply center piece.
2) Some EPP foam around the motor is removed for reducing prop noise.
3) Thin carbon sheets (pre-cured, uni-directional) are glued to each trailing edge uppersurface.
4) Several coats of water-based clear acrylic lacquer are applied to the ply center piece.
5) Factory supplied control wire rods are reinforced with carbon rods for solid control.

covering:

The wing uppersurface is covered with yellow colored tape, undersurface is with red colored tape. The balsa elevons are covered by yellow Oracover. The ESC is not covered for better cooling.


wing tip modification

After several flights, I decided to enlarge wing tips to increase stability. I made new tips from red coroplast. Then My MSW was a bit tail-heavy so I cut top and bottom of the center ply motor mount.


SpeedWing.NET
JustGoFly

last updated: Feb.3, 2011



fly with the wind > Mini SpeedWing 250